MicroBoards Technology MX SERIES Especificações descarregar pdf (Página 11)

MICROBOARDS TECHNOLOGY, LLC MX DISC PUBLISHER

Device Information

This page shows the Firmware version and Serial

Number of the print engine.

Clicking the Print Configuration Page button will print out

a test disc.

Clean

The Clean page allows you to run a cleaning cycle on

the ink cartridge.

Click the Clean button once a disc has been loaded into

the input hopper. If the resulting disc shows streaks

similar to those shown in the image on this page, you

may need to run the Clean utility again.

Printhead Maintenance

If, after several cleaning attempts, the printed images continue to show streaks of color, you may

need to manually clean the printheads. Follow the procedure below exactly to clean the printheads.

Not following these steps could result in damaged printheads.

1. Remove the printheads from the carriage (please see

Installing/Replacing Printheads, page 7).

2. Use ionized water to lightly dampen a lint-free cloth

3. Place the cloth on a level surface

4. Holding the printhead with the bottom of the printhead resting

lightly on the cloth, gently pull the printhead towards you

along the direction of the long axis of the printhead, as shown

to the right.

DO NOT MOVE THE PRINTHEAD FROM SIDE-TO-SIDE,

AS THIS COULD MIX THE INK COLORS IN THE

PRINTHEAD!

5. If the printhead does not leave two solid lines of color, one for

each color in the printhead, move the printhead to a clean

area on the cloth and repeat step 4.

6. Carefully replace the printhead in the MX Disc Publisher once

the heads have been cleaned.

If you do not follow the above procedure exactly, you could damage your printheads!

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

Sem comentários

MicroBoards Technology MX SERIES Especificações Página 11